Have questions? SBM sales representatives are available for live chat now WELCOME TO SBM MACHINERY!

Cost Of Construction Waste Recycling Plant

Cost Of Construction Waste Recycling Plant

Details of this product

Cost Of Construction Waste Recycling machine gear broken

             

When the gear of the Cost Of Construction Waste Recycling machine breaks, most of the bolts are considered loose, and the pinion shaft and the intermediate shaft are not guaranteed to have the same precision. But in addition to this, there are other reasons for gear breakage, as follows:

Ring gear bounce

Since the large ring gear of the Cost Of Construction Waste Recycling machine is bolted to the simplified body, the end face jump is adjusted by the top wire by the screw holes distributed on the circumference of the large ring gear.

Body vibration causes

When the Cost Of Construction Waste Recycling machine is running, frequent vibration occurs. If it is not treated in time, the seat will cause the pinion gear to vibrate due to the looseness of the extension shaft bearing seat. If the gear shaft and the extension shaft are not centered, the gear shaft center line and the extension shaft are tilted. Larger, causing the running gear to break.

Installation factor

The meshing of the Cost Of Construction Waste Recycling machine pinion and the large ring gear is very important. Reasonable installation can extend the service life of the Cost Of Construction Waste Recycling machine. However, when the large and small gears are installed, the large ring gear has been fixed with the cylinder, so we need to adjust. The position of the pinion gear requires that the pinion gear is parallel with the axial center line of the large ring gear, and the gap between the tooth tip and the tooth side is suitable. If it is too small, the undercut phenomenon is likely to occur, and the oversized gear is prone to breakage.

No car or car

Before stopping, it is necessary to stop feeding the mill to the mill, and empty the material in the Cost Of Construction Waste Recycling machine cylinder with water. Otherwise, the thick slurry will stick to the Cost Of Construction Waste Recycling machine and increase the load of the Cost Of Construction Waste Recycling machine next time. Even so, it is necessary to start the slow drive to drive the car before starting the Cost Of Construction Waste Recycling machine next time. This will not only form an oil film between the main bearing of the Cost Of Construction Waste Recycling machine and the hollow shaft, but also make the steel ball inside the mill. The material is loose. This greatly reduces the starting load when starting the mill. If the Cost Of Construction Waste Recycling machine does not drive before the start, the Cost Of Construction Waste Recycling machine will easily cause the pinion to break when it is started.

Get Price And Support

Simply complete the form below, click submit, you will get the price list and a SBM representative will contact you within one business day. Please also feel free to contact us by email or phone. ( * Denotes a required field).